You are reading a single comment by @Dom and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
Dom
You might be ok - it's then a matter of how much clearance you have between rotor and fork blade as you punt the rotor over with a spacer. Provided the fork's made correctly you should have 1-1.5mm to play with. You have to bare in mind that everything flexes a bit when loaded though so whilst it may clear everything fine in the workstand... it's a juggling act! Happy to send you some spacers but I'm not back in the UK until week after next.