You are reading a single comment by @WilliamJohn and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@WilliamJohn
So, off to uni soon so clearing out some stuff that isn't getting any use. Here we go.
All prices not including postage, based in Manchester, dibs then PM, first with the cash gets the bits.
The rear drive side bearing surface is screwed, as is the cone, the non-drive side is fine and the front hub is still spinning like new. Both have been laced up for the princely time of around three months, however realised loose balls aren't for me. Effectively front hub for sale with the rear free for spares like axle/cones. Both hubs complete with dust seals and all the gubbins attached.
Pretty scratched up but bought it polished and it's rather shiny. Could do with some assembly paste to keep it in place but to be honest I put the post slippage down to a slightly dodgy seatpost binder rather than the post.
Pedals are spinning absolutely fine, just not getting on with it and going back to clipless.
Bit reluctant to part with this, first bike my old boss brazed up, not sure on the tubing, 58cm seat tube, 55cm top tube, powdercoated green, doesn't include forks. Takes either 27/27.2 seatpost, 1" steerer, 8cm headtube. Could do with some reaming/facing post powdercoat.
Used them for half LEJOG, use saddlebags now, bit battered but working fine.