You are reading a single comment by @LRM and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
AngelD
@LRM
Rogan & AngelD
I did the mounts. What it did cost? Basicly nothing. Ok, I was too tired to braze the actual mounts and I didin't have gas on my torch, so I get the mounts brazed and that cost me like £15. Rest I loaned from frend's and so on. I glued the mounts to the fork with 3M panel bonding adheisive (same stuff that it used to glue non structural car panels. Roofs, door panels and so on) Next step was adding carbon fiber to the mix. They might just hold only with the adheisive, but because carbon fiber was available I give it a shot. - So I just basicly added carbon fiber (rovings) over the glueded mounts. When that was dried, I just shaped them way I liked with body kit.