For Sale: Lots o bits and pieces; bars, cranks, BBs, brake levers, DT shifters, pedals etc

So I have accumulated way too much stuff, mostly off here. This is my spare bits drawer, all for sale as I am going to uni in September and I need money more than I need these. I am in Cambridge; any item can be posted at cost. All prices are ONO. Thanks!

1) huge sprung saddle £5
2)black apollo saddle £5
3) Suicide levers. 2 pairs, £5/pair
4) Plastic pedals £3
5)Pannier Racks, £15 each
6) Shimano downtube shifters, £10
7)Shimano non-aero brake levers £5
8) Tektro RL720 brand new unused £18
9) Alpina 1 1/8" headset bits including top cap and spacers.. not sure if full headset or not. £5
10) Tranzx aero bars clip on £20
11) Suntour downtube shifters. There is some old cable stuck in one of the holes. £3
12) ITM 1" stem, £10
13) Custom stem, missing clamp bolt £4
14) Huret single downtube shifters £8 each
15) suntour front mech, worn. £4
16) shimano 105 front and rear mech £25
17) Sugino fluted seatpost, 26.6 £20
18)UNO 27.2 post £10
19) cannondale 27.2 £10
20)kalloy 26.8 post £10
21) SPD pedals, double sided. £18
22) Miche performance brakes, brand new unused £20
23) Front hub, low flange, 36h. £5
24) Neco square taper BB, £5
25) Shimano un54 square taper BB, £10
26)Miche BB, £10
27) Deda bar tape, blue, £8
28) Profile TT bars WITH two tektro bar end levers (one is missing a tiny wedge from the clamp). £30
29) Custom A crankset, alright for a beater £10
30) Plastic toe clips, new unused £5
31) Friko "super touring" bars £10
32) Raleigh bars £10
33) Shimano 105 octalink double crankset w/ BB £35

How wide are #32, Wardy?

I measured 37cm from the outside to outside, if that makes sense :)

Hi Wardy. Is the Shimano 105 crankset still going?

What's the reach in the miche performance brakes? Possible dibs

Crankset still available :)

The brakes are 57mm

Awesome. Can you put up a couple more photos of it please?

What diameter bars are the #10 clip on bars for? Thanks

The bars are for oversized bars I think, although it would be simple to shim them for smaller bars.

I'll get some pics up of the cranks shortly

I'm going to go for something else after all mate. Thanks for the photos anyway and GLWS