You are reading a single comment by @qwerty69 and its replies.
Click here to read the full conversation.
London Fixed Gear and Single-Speed is a community of predominantly fixed gear and single-speed cyclists in and around London, UK.
This site is supported almost exclusively by donations. Please consider donating a small amount regularly.
@qwerty69
I need to check out the price to get it done. If it's not too expensive I'll go down that route otherwise I'll clean up the rust and spray it.
As for bars, stem, seat, seat post etc I'm going to start amassing the parts and from what I can see these need not be expensive.
My concern I think will be the bottom half; I'm assuming it's just a matter of measuring between the forks to get a size for the front wheel and hub? And similarly at the rear or is it more tricky than this?